top of page

The only part touching your frame is the section of dropout where the skewer nut was. So there's no brackets, rubber rings or pads to scratch paintwork or carbon, or rattle as you ride.

 

Rain, hail or shine, us cyclists need to ride no matter what the weather. And when its wet, you need good bicycle mudguards that keeps you dry mile after mile. Quickguard™ bicycle mudguards have been especially designed with committed cyclists in mind. Once fitted it requires no tools to attach or remove, and is done in just a few seconds. The Quickguard bicycle mudguards extra long fender protects the cyclists behind from your spray, not just making riding in a group cleaner and more enjoyable, but much safer also.

 

The ONLY 
bicycle 
mudguards 
quick & easy 
to attach with 

full length
protection

Pre-Order Now

Here

Letting these muscles get wet can dramatically reduce your training comfort, duration and intensity.

 

Just over half of the pedalling down stroke power phase (as seen in red above) is generated from the glutes, so it only makes sense to keep those muscles dry and warm to train effectively.

 

The same can be said for your feet. If your feet get cold they will soon become dumb reducing your ability to put the power down. The Quickguard bicycle mudguards have been designed to fit both the rear and front wheels, and the low-ride design when used on the front wheel is what keeps your feet warm and dry. 

 

Quickguard bicycle mudguards are the most direct and effective way to eliminate cold road spray keeping your glutes and feet warm and dry, enabling you to train to the highest level in the rain and on wet roads.

4. Quickguard™  reduces your total weight in wet conditions

 

5. Quickguard™  has no wire stays and will not vibrate or rattle.

 

6. Quickguard™ is designed to fit both the rear and front wheels.

The Quickguard bicycle mudguards unique design allows the rider to change the position of the fender without tools, to lower its position on the wheel stopping up-spray to cyclists drafting behind you. Stopping the up-spray is a cleaner and more enjoyable group riding experience, as well as being much safer by stopping the up-spray to rider's eyes.

The water sprayed from the road is very cold, and without a mudguard can soak your chamois keeping your buttocks muscles (Glutes) cold and wet for hours, mile after mile.

Study conducted by Dr. Stephenson

1. Quickguard™  is quick

and easy to install and remove requiring no tools

 

2. Quickguard™  will not scratch or rub your frame's paint or carbon

 

3. Quickguard™  keeps you dry and stops up-spray to riders behind you

More reasons why to use Quickguard:

 

When riding in the rain most of the water making the rider wet comes from the road in the form of up-spray from the wheels. The diagram on the right shows the projection of water (dotted blue lines) off the rear and front wheels. A cyclists clothing can absorb and carry around 1 liter or 1 kg of water.

 

If the Quickguard bicycle mudguards are not used, the up-spray not only completely wets the rider, but also wets the riders sitting behind, making riding uncomfortable and less safe for everyone.

Quickguard makes you lighter!
Bicycle Quickguard photo gallery

WITHOUT Quickguard bicycle mudguards

200 grams of water

WITH Quickguard bicycle mudguards

0 grams of water

Cycling in the rain or on wet roads WITHOUT Quickguard bicycle mudguards will result in thoroughly soaked shorts and chamois, which could weigh as much as 650 grams.

Cycling in the rain or on wet roads WITH Quickguard bicycle mudguards will result in dry shorts and chamois, making you lighter, and more comfortable with warm muscles.

When riding on wet roads or in the rain cycling clothes can absorb roughly 450 grams of water from road spray alone. Using good bicycle mudguards or fenders may make your bike heavier but without them once wet your total weight is greater. Plus you are colder and over a long ride that cold will set in make your cycling less enjoyable and inefficient.

Cycling Shorts                                                       =200 grams

Water absorbed into shorts                               =450 grams

 

TOTAL                                                                    =650 grams

Cycling Shorts                                                      =200 grams

Water absorbed into shorts                              =0 grams

Quickguard bicycle mudguards                        =200 grams

 

TOTAL                                                                   =400 grams

Conclusion:

Using the Quickguard bicycle mudguards is 250 grams lighter than not using it in wet conditions.

How much does the Quickguard bicycle mudguards weigh?

The Quickguard bicycle mudguards weighs 200 grams.

 

Is there a Quickguard bicycle mudguard for the front wheel?

The one Quickguard bicycle mudguard can be used on both front and rear wheels. To fit Quickguard bicycle mudguard to the front wheel simply loosen the hex nut clamp and slide the whole guard to the right until the fender is aligned with your tyre. The bottom of the Quickguard bicycle mudguard should only be a few inches from the road and below your pedals at the bottom stroke. This unique design is what keeps your feet try.

 

Will the Quickguard bicycle mudguards fit on my bike?

The Quickguard bicycle mudguards are especially designed for all bikes with 700c wheels using a quick release. This includes road bikes, flat bar bikes, single speed bikes, hybrid bikes and recumbent bikes. The Quickguard bicycle mudguards will also fit any MTB with slim fitted tyres.

The answer is simple!

Will the Quickguard bicycle mudguards rattle like some other mudguards?

No, the Quickguard bicycle mudguards have no brackets or thin stays and small screws connected to your bicycle frame, so there is no parts to vibrate loose and rattle.

 

How easy is the Quickguard bicycle mudguards to fit?

The Quickguard bicycle mudguards are as simple as undoing the quick release and removing the skewer nut, screw on the Quickguard bicycle mudguards and tighten back up the quick release.

 

Will the Quickguard bicycle mudguards scratch my bike?

No, the Quickguard bicycle mudguards mount to your wheels, not your frame. The only contact the Quickguard bicycle mudguards have with your bike is at the wheel dropout, the same contact it currently has when your wheels are in your bike.

How does the Quickguard bicycle mudguards help me train better?

The water on the road is cold, and without Quickguard bicycle mudguards that water will spray up and onto your bottom and hamstrings. Once your chamois gets wet that cold water will chill your glutes and hamstrings. These muscles are major contributors to pedaling power and when cold will not perform at 100%.

 

The Quickguard bicycle mudguards will keep you dry and your muscles warm, enabling you to train at your highest level and as if the roads were dry.

 

What material is the Quickguard bicycle mudguards made from?

The fender part of the Quickguard bicycle mudguard is made from lightweight plastic, while the stays and skewer nut are aluminum making the Quickguard bicycle mudguards lightweight plus strong and rigid.

Contact

If you have any questions about Quickguard bicycle mudguards please use the contact form on the right, we will reply with an answer within 24 hours.

 

If you are a store and would like to stock Quickguard bicycle mudguards in your store also please use the contact form on the right, we will reply within 24 hours.

Quickguard is attached to the wheels NOT your frame 
Get more power in the rain with this new bicycle mudguard
Safer for bunch riding
when in wet conditions

Name *

Email *

Subject

Message

Your details were sent successfully!

bottom of page